Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Converting AP Model CAP2620I-E-K9 from lightweight to autonomous

Hi all,

 

While working on a site, I found the following problem.

 

I need to convert an AP model CAP2620I-E-K9 from lightweight to autonomous.

 

It is using the following IOS/firmware stored in flash: "flash/ap3g2-rcvk9w8-mx/ap3g2-rcvk9w8-xx"

 

A show ip int brief reveals only the following interfaces:

 

BVI1

GigabitEthernet0

GigabitEthernet0.1

 

No wireless interfaces at all.

 

I presume that a new firmware will be needed to make it work as autonomous.

 

My questions are:

 

1) Which firmware do I need?

2) Can it be downloaded from Cisco?

3) Should I use ftp to upload the firmware to the AP?

 

Thank you in advance for your help.

 

Best Regards,

 

Davide Ferreira

 

Everyone's tags (1)
1 REPLY
VIP Purple

Hi,1. Here is the link to

Hi,

1. Here is the link to download:http://software.cisco.com/download/release.html?mdfid=284362257&flowid=34153&softwareid=284180979&release=15.3.3-JAB&relind=AVAILABLE&rellifecycle=ED&reltype=latest

2. Yes its from cisco but you need to have valid contract.

3. Yes you can use FTP or TFTP.

How to convert From lAP to autonomous mode:

http://rscciew.wordpress.com/2014/05/07/access-point-conversion-lap-to-aap-and-vice-versa/

https://www.youtube.com/watch?v=QQ_NuxdRhQ4

 

Regards

Dont forget to rate helpful posts

 

91
Views
5
Helpful
1
Replies
CreatePlease to create content