Copy SSC to a new controller

[qlgendrano]

Hello,

Anyone knows how to copy the SSC from AP Policy page from one controller to another?  I have accumulated 134 access points with SSC and I need to copy them to a new controller. Is there an easy way (one time) of doing this?

[dancampb · Accepted solution]

Depending on the version you are running capture the output of either "show running-config" or "show run-config commands" from the controller.  In the output you'll see " auth-list add ssc ".  Copy these entries.

Go to the new controller and type "config" and hit enter.  You're prompt will change to "(Cisco Controller) config>"

Paste in the auth-list entries you copied from the old controller's config.

[qlgendrano]

Thanks! I copied the output of show auth-list, pasted in notepad and added auth-list add ssc to all the entries.

It requires a little time to edit but at least I didn't have to do each entry one by one.

[George Stefanick]

Little hint ... if you do the show run-config [no-ap], will save yourself the trouble of looking through a ton of APs...