Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

D-WEP with 340 Series Bridge in AP mode

I'm trying to setup a 340 Series Bridge to do dynamic WEP. The device is set to be an access point, but I still don't see the option.

The bridge is running firmware V8.24.

Is this possible? Thanks

1 REPLY
Silver

Re: D-WEP with 340 Series Bridge in AP mode

I think you’re referring to LEAP which is in 8.55 and newer. 8.24 is pretty old and buggy so there are a lot of reasons to upgrade the firmware.

173
Views
0
Helpful
1
Replies
CreatePlease to create content