Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

DHCP for H-REAP clients

Dear All,

I have extened my coporate office wireless network to my branch locations using H-REAP. While connecting  to this wireless netwrok from the branch locations I am getting the IP address from corporate office DHCP server. Is it possible to get IP addresses from the local DHCP servers at the branches ?

WLC - 5508

AP - 1242

Regards,

Shijo.

  • Other Wireless - Mobility Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: DHCP for H-REAP clients

You need to look at this guide. You need to assign the WLAN the vlan mapping and make sure the AP is connected to a trunk port. Also on the WLAN, you need to enable local switching.

https://supportforums.cisco.com/docs/DOC-24082

Sent from Cisco Technical Support iPhone App

Thanks, Scott *****Help out other by using the rating system and marking answered questions as "Answered"*****
3 REPLIES
Hall of Fame Super Silver

Re: DHCP for H-REAP clients

You need to look at this guide. You need to assign the WLAN the vlan mapping and make sure the AP is connected to a trunk port. Also on the WLAN, you need to enable local switching.

https://supportforums.cisco.com/docs/DOC-24082

Sent from Cisco Technical Support iPhone App

Thanks, Scott *****Help out other by using the rating system and marking answered questions as "Answered"*****
VIP Purple

Re: DHCP for H-REAP clients

If it is already configured for H-REAP local switching with correct vlan mapping, you have to make sure you configure correct "ip helper-address x.x.x.x" to pointing to branch DHCP server under SVI defined for wirless users at branch.

If DHCP server is the same switch where you defined the SVI then it is not mandatory.

HTH

Rasika

New Member

DHCP for H-REAP clients

Hi Scott,

Thank you very much. Its working now.

Regards,

Shijo.

160
Views
0
Helpful
3
Replies