I currently have a 1200 AP providing DHCP for wireless users on a single floor of a govt. bldg. Wireless and wired connections are on different subnets. My AP is issuing IP addresses to not only the wireless cards, but the wired as well. How can I make sure that the AP only assigns IP's to a wireless device, without disabling the onboard wired NIC?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...