Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

DHCP problems

After upgrading controller to 5.2.157 (also tried 5.1.151 with same result) I have problems to get a DHCP address to the accesspoints. It works if I reboot the controller, but if I disables the power to an AP and enables it again, making the AP to reboot, it can't get an adress. If I debug DHCP in the controller, I see this:

*Dec 16 09:09:03.149: 00:21:9b:70:a1:06 DHCP dropping packet (no mscb) found - (giaddr 0.0.0.0, pktInfo->srcPort 68, op: 'BOOTREQUEST')

I have tried to find a solution to this, but with no luck. Any Ideas?

1 REPLY

Re: DHCP problems

Personally I would downgrade to a non "Early Deployment" release, I know that 5.2 only came out about a month ago.

HTH>

593
Views
0
Helpful
1
Replies
CreatePlease to create content