I've been working with Cisco 1310 bridges and 1231 APs. So far, I have used the browser to configure the bridges. I'm wondering is there a need to know the IOS commands to configure them. Does the IOS give more features to configure?. Or knowing IOS has any special advantage over configuring through browser?
For general configuration purposes the WebUI usually is sufficient. There usually are commands that are not in the WebUI that can be enabled via the cli. You can usually get more granularity from the cli than the webUI.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...