I have a LAP1252AG-E-K9 managed by a WLC embedded in a Catalyst3750G. My question is the following: how can I disable the 5GHz radio module using the WLC (I desire leave only the 2.4GHz module). In addition : in case I put in the LAP only 3 2.4Ghz antennas the 5GHz module is automatically disable?
You should be able to go to the Wirless -> AP's -> Radios -> 802.11a/n AP's and choose to configure the AP. Once you are on the config screen, you can administratively disable the 802.11a/n radio on the 1250.
I haven't tested this but I beleive I've read that just disabling the radio via controller doesn't actually solve power problems- if you're trying to get full power to one 2.4 radio using just 15.4 watts, I believe you do have to physically uninstall the other radio.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...