Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Disassociate APs from controller

hi

we have two controllers with 32 APs. Today all the APs associated to 1st controller got de-associated.Eventhough it did not associated to 2nd controller.

Can someone advise me why this has happend and what are the required configurations needed to work active/standby or share the AP association between two controllers.

thanks in advance !

2 REPLIES
Hall of Fame Super Silver

Re: Disassociate APs from controller

Mobility must be configured and working properly. Here are some links to help you out. AP Fallback also muct be configured and I put a link here also:

http://www.cisco.com/en/US/tech/tk722/tk721/technologies_tech_note09186a00807a85b8.shtml

http://www.cisco.com/en/US/products/ps6366/products_qanda_item09186a00809a30cc.shtml

-Scott
*** Please rate helpful posts ***
Hall of Fame Super Gold

Re: Disassociate APs from controller

What is the Firmware of the two WLC?

If v3.x/4.x/5.x (before 5.2), try the following commands from the WLC:

config ap primary-base

config ap secondary-base

This forces the AP to "point" to the primary/secondary WLC immediately after bootup.

If your Firmware is 5.2, then use the command:

config advanced backup-controller primary

config advanced backup-controller secondary

Does this help?

176
Views
0
Helpful
2
Replies
CreatePlease to create content