Is there a way to display counters -- including physical layer errors -- on the dual RG-6 cable linking the AP to its power injector?
Seems to me that 'sh int' displays counters for the dot11Radio0 interface (in the AP) and for the FastEthernet0 interface (the RJ-45 in the power injector) ... but I don't see anything corresponding to an interface to the coax cable running between the two. [BTW: does anyone know what protocol runs over the coax? Ethernet-over-shielded-RG, I suppose ... does this have a specific name?)
I believe that my coax has been damaged (water penetration), and I'm looking for a way to quantify physical layer problems with transmission over it.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...