We have few workgroup bridge access points, which do not associate with the proper parent access point. sometimes workgroup bridges associate with another access point which is much farthest than the nearest access point.
what might be the possible reasons for them not associating to the nearest access point. the nearest access point is about 50m & the farthest one which they try to associate with is about 150m. some are directional and some are omni directional antenna.
Could be a poor signal quality between the WGB and the closets AP or maybe that close AP is real busy. Have you looked at the utilization, client count, etc. you can force WGB to a parent by specifying the parent radio mac address to if you want.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...