Guys Im trying to setup Guest access for our visitors.
I have 4 internal controllers up and running with v4.1.185 and no issues. We have just purchased an additional WLC that we want to setup on our DMZ for guest access.
We have done all required Anchor/Mobility configurations on all controllers (Internal & DMZ). I can ping to/from the internal controllers to the DMZ controller with no issues. But my mpings and epings are failing and my data and control paths are not all up. Im pretty sure that this is a PIX issue not allowing the correct ports to/from the controllers. Iam not a security guy ao Im a little confused on what configs need to happen on the PIX to allow these ports. Can someone please assist me with the PIX configurations?
Guys, I have passed along the list of ports that need to be open to our PIX support team (AT&T). I am not a security guy so i will like to know what these commands should look like so that i can confirm that AT&T is doing it correctly. If possible can someone please post what these commands should look like om the PIX? Any help would be great!!!
I wish I had one from my clients, but they are all different. Depending on what inside devices are used for dns, tftp, etc, that will be unique per location. Just make sure they have these ports (12222, 12223, 16666, 16667, ip protocol 97) open both ways from the anchor wlc to all foreign wlcs in side (management ip). SNMP (udp 161, 162) need to be open both ways to your WCS if you have one.
Just have them put the rules in and if you have issues, have them post the pix config for that.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...