I have deployed mesh solution in location A and now i have to install 2 unit of 1522 in location B, my WLC is currently installed at location A, can use the same controller and enable any REAP function so that i no need to buy another WLC. Both location A and Location B are connected using a lease line.
just a small confirmation to make it correct. each MESH AP is considered as 1/2 AP in the controller, am i correct to say this ? example i have 12 units MESH AP & 12 Units of AP1242, can i use WLC2112 to bring all the 24 Units AP.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...