Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Does AP1131G support feature 'multiple ssid'?

Hello

I've checked in feature navigator and I've seen AP1131G doesn't support multiple ssid feature. It's right?

If yes, What is replacement AP for AP1121?

I can't order old good AP1121 so I need good replacement for it.

Thank you!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Does AP1131G support feature 'multiple ssid'?

Hi Pavel,

Just to add a clip to the good tips from Dan and Lucien (+5 points each guys :)

From the 1130 Quick Start Guide;

When the access point configuration is set to factory defaults, the first SSID that you create by using the Express Security page overwrites the default SSID, which has no security settings. The SSIDs that you create appear in the SSID table at the bottom of the page.** You can create up to 16 SSIDs on the access point.

http://www.cisco.com/en/US/docs/wireless/access_point/1130/quick/guide/ap1130qs.html#wp32816

Hope this helps!

Rob

6 REPLIES
Gold

Re: Does AP1131G support feature 'multiple ssid'?

Sure, you can create multiple SSIDs on the 1130's.

Community Member

Re: Does AP1131G support feature 'multiple ssid'?

So Cisco feature navigator is wrong?

Re: Does AP1131G support feature 'multiple ssid'?

Pavel,

Between 8 to 16 SSID for the 1130, depending if you have MBSSID or SSID.

IF you see an error for the feature navigator, there is a submit feedback place you can report it.

Check out the documentation for the 1130:

http://www.cisco.com/en/US/products/ps6087/index.html

Datasheet, white papers..

Community Member

Re: Does AP1131G support feature 'multiple ssid'?

Thank you for you advise and links.

But I can't find any information about multiple ssid feature on cisco site. Only in feature navigator. :) And it says me that multiple ssids feature isn't support in 1131 ioses.

P.S. I will use access point in standalone mode not lwapp.

Hall of Fame Super Red

Re: Does AP1131G support feature 'multiple ssid'?

Hi Pavel,

Just to add a clip to the good tips from Dan and Lucien (+5 points each guys :)

From the 1130 Quick Start Guide;

When the access point configuration is set to factory defaults, the first SSID that you create by using the Express Security page overwrites the default SSID, which has no security settings. The SSIDs that you create appear in the SSID table at the bottom of the page.** You can create up to 16 SSIDs on the access point.

http://www.cisco.com/en/US/docs/wireless/access_point/1130/quick/guide/ap1130qs.html#wp32816

Hope this helps!

Rob

Community Member

Re: Does AP1131G support feature 'multiple ssid'?

Thank you

392
Views
18
Helpful
6
Replies
CreatePlease to create content