The 350 is not going to work due to the required IOS needed to function with the WLC 220.127.116.11. Have a look;
Workgroup bridge (WGB) support - Cisco Aironet autonomous access points operating in WGB mode can now associate to Cisco Aironet lightweight access points (except Cisco Airespace AP1000 series access points) to provide an 802.11 wireless connection to wired devices. The WGB is supported only in client mode and not in infrastructure mode and must run Cisco IOS Release 12.4(3g)JA or later (on 32-MB access points) or Cisco IOS Release 12.3(8)JEB or later (on 16-MB access points). WGB functionality is not supported for use with hybrid REAP.
The autonomous WGB access point learns the MAC address of the wired client and then informs the lightweight access point and controller that the device is operating on the wireless network. This scenario provides transparent bridging for wired clients and secure roaming.
These release notes describe minor features and caveats for Cisco IOS Maintenance Release 12.3(8)JEB. They also provide important information about Cisco Aironet 1100, 1200, and 1230 series autonomous access points. The Cisco Aironet 350 series is no longer supported in this release or any future release.
These release notes describe features, enhancements, and caveats for special technology early deployment release Cisco IOS Release 12.4(3g)JA. Release 12.4(3g)JA supports 32 Mb Cisco autonomous access points including Cisco Aironet 1100, 1130, and 1240 series access points, 1300 series access point/bridges, and 1400 series bridges.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...