Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

dot11 carrier busy command

I am getting 100% busy on all channels when running a "dot carrier busy" command on an AP, other APs close by are OK, so I take it there must be a radio fault, is thereany fix for this?

2 REPLIES
Anonymous
N/A

Re: dot11 carrier busy command

This might be a fault with Radio. Try to reset the AP and check again. You can also try upgrading the software.

Re: dot11 carrier busy command

reloading the AP made no difference,seems to bea H/W problem, so the APs have been swapped out

150
Views
0
Helpful
2
Replies
CreatePlease to create content