I have a cisco 1400 that that show interface show int dott1 radio interface reset protocol down. I had a surge in the area and had the problem after. I copied the config over to a new Ap and power injector and the problem persists. The bridge is the non root bridge. I had read a caveat cscea75989 but it said take no action. Take no action is not fixing my problem at this time. Any suggestions would be appreciated. Thanks.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...