cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4940
Views
10
Helpful
5
Replies

Dot11Radio0 is reset, line protocol is down

chong.eric
Level 1
Level 1

Any idea what happen? I can't detect SSID from my AP.

5 Replies 5

irisrios
Level 6
Level 6

Check if the Radio is administratively enabled. On GUI , Go to Network Interfaces --> Radio 802.11G / Radio 802.11A . Under Setings Enable the Radio. Also make sure atleast one SSID is created.

dldjtad12
Level 1
Level 1

Check the following line in the AP. The MAC address at the end must

corrospond with the port that AP is plugged into at the

switch.

power inline negotiation injector 000d.6563.0518

Leo Laohoo
Hall of Fame
Hall of Fame
Any idea what happen? I can't detect SSID from my AP.

Console into the WAP and reboot the WAP.  Post the entire bootup process and even the part where the WAP joins the controller.

Also post the following output:

1.   WAP:  sh version;

2.  WAP:  sh inventory; and

3.  WLC:  sh sysinfo

Saravanan Lakshmanan
Cisco Employee
Cisco Employee

Are other APs fine.

Does it happen after code upgrade.

Check if AP group used and WLANs added to it.

maldehne
Cisco Employee
Cisco Employee

Just to save your time and use systematic approach instead of try and error,

Please attach the show tech from the AP ?

How is it powered?

If through POE , show power inline output form the switch at which the AP is connected. Highlight the port at which the AP is connected.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: