Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

DTLS handhake

I am not able to get the Aps to join WLC.

i have wlc 5760 with version 03.03.01SE.

below is the error message i am getting on the controller:

*%DTLS-3-HANDSHAKE_FAILURE: 1 wcm:  Failed to complete DTLS handshake with peer 10.87.1.2  for AP 0000.0000.0000Reason: sslv3 alert bad certificate

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Re: DTLS handhake

Hi,

CSCO11256353 wrote:

i configured time settings now DTLS errors are gone. but instead i am getting these below messages:

*%LWAPP-3-RD_ERR7: 1 wcm: Invalid country code () for AP 3c:08:f6:d9:22:90

*%LOG-3-Q_IND: 1 wcm:  Invalid country code () for AP 3c:08:f6:d9:22:90

*%LWAPP-3-VALIDATE_ERR: 1 wcm:  Validation of SPAM Vendor Specific Payload failed - AP  3c:08:f6:d9:22:90

*%LOG-3-Q_IND: 1 wcm:  Validation of SPAM Vendor Specific Payload failed - AP  3c:08:f6:d9:22:90

*%LWAPP-3-RD_ERR7: 1 wcm:  Invalid country code () for AP 3c:08:f6:d9:22:90

*%LWAPP-3-RD_ERR4: 1 wcm:  Invalid regulatory domain 802.11bg:-A     802.11a:-A for AP 3c:08:f6:d9:22:90


*%LOG-3-Q_IND: 1 wcm:  Invalid country code () for AP 3c:08:f6:d9:22:90

As per these logs your country code iis wrong on WLC:

You must check the country code on WLC:

As your AP says thhat you are in USA.(-A-)

Correct and try again.

Reagrds

Dont forget to rate helpful posts

5 REPLIES
VIP Purple

DTLS handhake

paste the sh version from AP:

Reagrds

New Member

DTLS handhake

i configured time settings now DTLS errors are gone. but instead i am getting these below messages:

*%LWAPP-3-RD_ERR7: 1 wcm:  Invalid country code () for AP 3c:08:f6:d9:22:90

*%LOG-3-Q_IND: 1 wcm:  Invalid country code () for AP 3c:08:f6:d9:22:90

*%LWAPP-3-VALIDATE_ERR: 1 wcm:  Validation of SPAM Vendor Specific Payload failed - AP  3c:08:f6:d9:22:90

*%LOG-3-Q_IND: 1 wcm:  Validation of SPAM Vendor Specific Payload failed - AP  3c:08:f6:d9:22:90

*%LWAPP-3-RD_ERR7: 1 wcm:  Invalid country code () for AP 3c:08:f6:d9:22:90

*%LWAPP-3-RD_ERR4: 1 wcm:  Invalid regulatory domain 802.11bg:-A     802.11a:-A for AP 3c:08:f6:d9:22:90

*%CAPWAP-3-POST_DECODE_ERR: 1 wcm:  Post decode processing failed for Config status from AP 3c08.f6d9.2290

%LINK-3-UPDOWN: Interface Capwap0, changed state to up

*%CAPWAP-3-DATA_TUNNEL_UPDATE_ERR1: 1 wcm:  Failed to send CAPWAP data tunnel update for AP: 3c08.f6d9.2290 with interface id: 0x5758c00000001a. Renstallation since AP connection is being deleted!

*%CAPWAP-3-INVALID_STATE_EVENT: 1 wcm:  Invalid AP event (CAPWAP Configuration Update Request) and state (CAPWAP Join Response) combination

%LINEPROTO-5-UPDOWN: Line protocol on Interface Capwap0, changed state to up

*%LWAPP-3-RD_ERR7: 1 wcm:  Invalid country code () for AP 3c:08:f6:d6:15:90

*%LOG-3-Q_IND: 1 wcm:  Invalid country code () for AP 3c:08:f6:d6:15:90

*%LWAPP-3-VALIDATE_ERR: 1 wcm:  Validation of SPAM Vendor Specific Payload failed - AP  3c:08:f6:d6:15:90

*%LOG-3-Q_IND: 1 wcm:  Validation of SPAM Vendor Specific Payload failed - AP  3c:08:f6:d6:15:90

*%LWAPP-3-RD_ERR7: 1 wcm:  Invalid country code () for AP 3c:08:f6:d6:15:90

*%LWAPP-3-RD_ERR4: 1 wcm:  Invalid regulatory domain 802.11bg:-A     802.11a:-A for AP 3c:08:f6:d6:15:90

*%CAPWAP-3-POST_DECODE_ERR: 1 wcm:  Post decode processing failed for Config status from AP 3c08.f6d6.1590

%LINK-3-UPDOWN: Interface Capwap1, changed state to up

*%CAPWAP-3-DATA_TUNNEL_UPDATE_ERR1: 1 wcm:  Failed to send CAPWAP data tunnel update for AP: 3c08.f6d6.1590 with interface id: 0x4572000000001b. Re

nstallation since AP connection is being deleted!

*%CAPWAP-3-INVALID_STATE_EVENT: 1 wcm:  Invalid AP event (CAPWAP Configuration Update Request) and state (CAPWAP Join Response) combination

%LINEPROTO-5-UPDOWN: Line protocol on Interface Capwap1, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface Capwap0, changed state to down

%LINEPROTO-5-UPDOWN: Line protocol on Interface Capwap1, changed state to down

*%LWAPP-3-RD_ERR7: 1 wcm:  Invalid country code () for AP 3c:08:f6:d9:22:90

*%LOG-3-Q_IND: 1 wcm:  Invalid country code () for AP 3c:08:f6:d9:22:90

*%LWAPP-3-VALIDATE_ERR: 1 wcm:  Validation of SPAM Vendor Specific Payload failed - AP  3c:08:f6:d9:22:90

*%LOG-3-Q_IND: 1 wcm:  Validation of SPAM Vendor Specific Payload failed - AP  3c:08:f6:d9:22:90

*%LWAPP-3-RD_ERR7: 1 wcm:  Invalid country code () for AP 3c:08:f6:d9:22:90

*%LWAPP-3-RD_ERR4: 1 wcm:  Invalid regulatory domain 802.11bg:-A     802.11a:-A for AP 3c:08:f6:d9:22:90

*%CAPWAP-3-POST_DECODE_ERR: 1 wcm:  Post decode processing failed for Config status from AP 3c08.f6d9.2290

%LINK-3-UPDOWN: Interface Capwap0, changed state to up

*%CAPWAP-3-DATA_TUNNEL_UPDATE_ERR1: 1 wcm:  Failed to send CAPWAP data tunnel update for AP: 3c08.f6d9.2290 with interface id: 0x46ad000000001c. Re

nstallation since AP connection is being deleted!

*%CAPWAP-3-INVALID_STATE_EVENT: 1 wcm:  Invalid AP event (CAPWAP Configuration Update Request) and state (CAPWAP Join Response) combination

%LINEPROTO-5-UPDOWN: Line protocol on Interface Capwap0, changed state to up

*%LWAPP-3-RD_ERR7: 1 wcm:  Invalid country code () for AP 3c:08:f6:d6:15:90

*%LOG-3-Q_IND: 1 wcm:  Invalid country code () for AP 3c:08:f6:d6:15:90

*%LWAPP-3-VALIDATE_ERR: 1 wcm:  Validation of SPAM Vendor Specific Payload failed - AP  3c:08:f6:d6:15:90

*%LOG-3-Q_IND: 1 wcm:  Validation of SPAM Vendor Specific Payload failed - AP  3c:08:f6:d6:15:90

*%LWAPP-3-RD_ERR7: 1 wcm:  Invalid country code () for AP 3c:08:f6:d6:15:90

*%LWAPP-3-RD_ERR4: 1 wcm:  Invalid regulatory domain 802.11bg:-A     802.11a:-A for AP 3c:08:f6:d6:15:90

*%CAPWAP-3-POST_DECODE_ERR: 1 wcm:  Post decode processing failed for Config status from AP 3c08.f6d6.1590

%LINK-3-UPDOWN: Interface Capwap1, changed state to up

*%CAPWAP-3-DATA_TUNNEL_UPDATE_ERR1: 1 wcm:  Failed to send CAPWAP data tunnel update for AP: 3c08.f6d6.1590 with interface id: 0x69fb800000001d. Re

nstallation since AP connection is being deleted!

*%CAPWAP-3-INVALID_STATE_EVENT: 1 wcm:  Invalid AP event (CAPWAP Configuration Update Request) and state (CAPWAP Join Response) combination

%LINEPROTO-5-UPDOWN: Line protocol on Interface Capwap1, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface Capwap0, changed state to down

%LINEPROTO-5-UPDOWN: Line protocol on Interface Capwap1, changed state to down

*%LWAPP-3-RD_ERR7: 1 wcm:  Invalid country code () for AP 3c:08:f6:d9:22:90

*%LOG-3-Q_IND: 1 wcm:  Invalid country code () for AP 3c:08:f6:d9:22:90

VIP Purple

Re: DTLS handhake

Hi,

CSCO11256353 wrote:

i configured time settings now DTLS errors are gone. but instead i am getting these below messages:

*%LWAPP-3-RD_ERR7: 1 wcm: Invalid country code () for AP 3c:08:f6:d9:22:90

*%LOG-3-Q_IND: 1 wcm:  Invalid country code () for AP 3c:08:f6:d9:22:90

*%LWAPP-3-VALIDATE_ERR: 1 wcm:  Validation of SPAM Vendor Specific Payload failed - AP  3c:08:f6:d9:22:90

*%LOG-3-Q_IND: 1 wcm:  Validation of SPAM Vendor Specific Payload failed - AP  3c:08:f6:d9:22:90

*%LWAPP-3-RD_ERR7: 1 wcm:  Invalid country code () for AP 3c:08:f6:d9:22:90

*%LWAPP-3-RD_ERR4: 1 wcm:  Invalid regulatory domain 802.11bg:-A     802.11a:-A for AP 3c:08:f6:d9:22:90


*%LOG-3-Q_IND: 1 wcm:  Invalid country code () for AP 3c:08:f6:d9:22:90

As per these logs your country code iis wrong on WLC:

You must check the country code on WLC:

As your AP says thhat you are in USA.(-A-)

Correct and try again.

Reagrds

Dont forget to rate helpful posts

VIP Purple

DTLS handhake

Make sure time setting on WLC is up to date

Regards

New Member

DTLS handhake

becuase of these erros aps are bouncing.

2200
Views
0
Helpful
5
Replies
CreatePlease to create content