Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Dynamic Interfaces w/Multiple WLC's & SSID's/VLAN's

The setup I'm working on will use 3-WLC's with 6 user SSID's. The deployment guide and config guide state that I should configure a dynamic interface for each VLAN and assign an IP address, then assign each SSID to their respect VLAN.

Does a virtual interface assigned to a corresponding VLAN on different controllers get assigned a different IP address?

WLC-A -->SSID:Faculty1-->VLAN 10-->>IP: 10.0.0.1

WLC-B -->SSID:Faculty1-->VLAN 10-->>IP: 10.0.0.2

WLC-C -->SSID:Faculty1-->VLAN 10-->>IP: 10.0.0.3

1 REPLY
Community Member

Re: Dynamic Interfaces w/Multiple WLC's & SSID's/VLAN's

Your dynamic interfaces look good.

All controllers should have the same virtual IP addresses, typically 1.1.1.1 - this is used more for inter-controller mobility.

197
Views
0
Helpful
1
Replies
CreatePlease to create content