Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Dynamic Interfaces

On to my next issue:

I'm setting up a lab enviornment -

Cat6506 - 12.2(18)SXF5

WiSM 4.1.171.0

Virtual Int: 1.1.1.1

Service Port: 192.168.10.x

Mgt Int: 40.88.160.1/28 VLAN 40

AP Mgt: 40.88.160.1/28 VLAN 40

WEP: 40.88.160.32/28 VLAN 50

LEAP: 40.88.160.48/28 VLAN 60

PEAP/WPA2: 40.88.160.64/28 VLAN 70

When trying to configure Dynamic Interfaces for VLANs 50-70 I keep getting Invalid Address Information Provided.

Any ideas besides don't come into work at 5:30am to work on this stuff?

3 REPLIES
Bronze

Re: Dynamic Interfaces

It is recomended to put the dynamic interfaces, management interfaces, virtual inteface and service port into different major subnets.

Zhenning

New Member

Re: Dynamic Interfaces

Zhenning- where did you see that, please? I just tried and was able to configure on my WLC just fine. See attached for detailed info.

New Member

Re: Dynamic Interfaces

Thanks for the info. I got it to work...it helps putting in the correct gateway address. >.<

172
Views
0
Helpful
3
Replies
CreatePlease to create content