Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

enough power

hi,

i am un able to find my LWAP in WCS but in WLC i can find this.in WLC the oppration status is down and in mesg's it is showing "ap is un able draw enough power".please help me to resolve this issue....

regards,

Satya.M

4 REPLIES

Re: enough power

What AP? If a 1242, 1230, or 1130 it could be a CDP issue on the switch misreporting the availability of power from the port. If it is a 1252 then you must use a 802.3at device to power it.

New Member

Re: enough power

hi,

i am having 1130LWAP with power inj....

Silver

Re: enough power

You may also need to configure the WLC to accept whatever power supply you're using. Go to the Wireless tab in the WLC GUI and click on your access point. Click on the Advanced tab to modify the power settings. Check the appropriate box if you're using a power injector or a pre-standard powered switch.

Re: enough power

Correct Jeff. If he is using a substandard 802.3af device like the older Cisco units (the pre 802.3af) he will get this error as well.

138
Views
0
Helpful
4
Replies