Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Error! cannot enable extended adj rogue

I need a little help.

When enabling Adjacent Channel Rogue (Management>Trap Controls>Security), I get the following error:

Error! cannot enable extended adj rogue.

Why do I get this error?

Reading the WLC help pages, I did not see any documentation on this error nor enabling Adjacent Channel Rogue.

Searching the Cisco Wireless LAN Controller Configuration Guide, Release 7.4, I did read any documentation on this error nor enabling Adjacent Channel Rogue.

1 REPLY
Hall of Fame Super Silver

Re: Error! cannot enable extended adj rogue

I never use it, but it probably give you an error because you are not either using monitor mode APs or RLDP enabled. You don't want to enable RLDP either just to let you know. Here is more info on rogue detection and does explain the caveats to using RLDP.

http://www.cisco.com/en/US/products/ps6366/products_tech_note09186a0080b40901.shtml

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
137
Views
0
Helpful
1
Replies