Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Error in AP1250

Hi,

I have installed an AP 1250 , i would like to check whether the device will support 802.11 A ,G Series Adapter

4 REPLIES
New Member

Re: Error in AP1250

When you say 802.11 A,G Adapter, or you saying for the client? What kind of error are you getting?

New Member

Re: Error in AP1250

Hi,

The error I have faced after installation of AP 1250 was releated to the Client adapter.

My doubt whether my client adapter which is in 802.11 a /b/g will support AP 1250 which is in 802.11 n.

New Member

Re: Error in AP1250

Would the client not associate to the AP? Does the AP see the client trying to associate? In a nutshell, 802.11n just aggregates multiple a or g radios. The 802.11n is also an a/b/g radio. If this is a new install, I would check to make sure you have enabled the radios as the radios are disabled from the factory. I hope this helps...

New Member

Re: Error in AP1250

Hi Slapham,

Thanks for your feedback,there was a problem

at the Client Interface and hence the association did not take place with the AP the same was taken care, Thanks for your support.

176
Views
0
Helpful
4
Replies