I'm getting this error in the log of the WLC. This error showed after a power outage and the switch that WLC was connected to lost its config. It has since been replaced and is up although my wireless network is down for oth data and voice. I'm a newbie so I need a little help with this one. Thanks in advance. Error message is below:
LWAPP-3-DISC_INTF_ERR1: Ignoring discovery request received on non-management interface (2) in L3 LWAPP mode
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...