We are having a strange issue taht i am sure others have run into before.
Currently we have a WLC 5508 with 2 1552 Outdoor Mesh APs running code 184.108.40.206.
We one configured as RAP and one as MAP. This is essentially setup just as a backhaul (trunk link). We ahve the RAP setup as Normal and the MAP setup for Trunk. We have configured to pass all VLANs we need (pruning). The mesh link works as expected the only issue is when we try to connect a client to a access port (VLAN 18) on a switch the MAP side (ethernet bridged). We are unable to get a IP address assigned.
However. We can statically configure an address in that network and Unicast traffic works just fine. It appears the broadcast traffic is not making it across the Mesh link.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...