Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Factory Defaulting 4402

We have a lab controller (4402) that no one seems to know the password for. Is there a way to do a factory reset without having been logged in first?

i don"t mind losing the existing configuration>

thanks

2 REPLIES
Hall of Fame Super Silver

Re: Factory Defaulting 4402

I believe you can reboot the WLC while you are consoled in and then during boot up there will be a prompt to hit 'ESC'. There should be an option to reset the WLC to facory or maybe it is clear configuration. hope this helps. Haven't done this in a while.

-Scott
*** Please rate helpful posts ***
Cisco Employee

Re: Factory Defaulting 4402

Connect to the console and reboot the WLC. After it's finished loading, at the username prompt, type 'Recover-Config'.

By the way; a distant relative perhaps ;)

108
Views
0
Helpful
2
Replies
CreatePlease to create content