Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Factory Reset for AP 1010

Hi all,

One of my AP 1010 got a static IP in vlan 110 Range but Controller is in Different(default) Vlan. Due to this its not getting registerd with WLc. Anybody can suggest any procedure to remove that IP from AP.

3 REPLIES

Re: Factory Reset for AP 1010

My first post didnt show up so here we go again. The 1010 has a 2 pin console port inside of it to do a lwapp config to default factory reset. You open it up with a terminal session. This requires a special cable as well. The easiest way will be to get a spare controller and set the interfaces to be on the same network as the AP. Once it joins, reset the AP to factory defaults and reboot it. Make sure it comes back up then simply change it from static to dhcp and join it to the new network and controller via dhcp. Make sure all versions of code support the 1000 series APs.

New Member

Re: Factory Reset for AP 1010

Could you please let me know the type of cable should be used to get the access.?

Re: Factory Reset for AP 1010

I got mine from Airespace and have no clues as to which pins were pinned out on it. I haven't seen it in 2 years or I would open it up and look. It is a serial 9 pin to a small 2 pin connector.

895
Views
4
Helpful
3
Replies
CreatePlease to create content