Re: Failed to start driver for port "awc0"(error=0x00000000)
Check the config and make sure that your AP ports aren't configured with auxiliary vlans. Unless you plan on plugging in an IP phone to the same port as the AP you really only need to have the port configured for a single vlan. Hope that works for you.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...