cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
367
Views
0
Helpful
1
Replies

Failed to start driver for port "awc0"(error=0x00000000)

mcwck
Level 1
Level 1

Hi there ,

wonder does anyone come across above error message recorded in your AP logs ( as below )

b)Warning Failed to Send Packet on port "awc0" (error=0xffffffff)

a) FATAL Failed to start driver for port "awc0" (errno=0x00000000)

Clients have to reassociate with these AP after deassociated.shall send these AP for RMA ? pls share ..thks

1 Reply 1

Cisco_Kid
Level 1
Level 1

Check the config and make sure that your AP ports aren't configured with auxiliary vlans. Unless you plan on plugging in an IP phone to the same port as the AP you really only need to have the port configured for a single vlan. Hope that works for you.

Cheers!

Cisco_Kid

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: