Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Failed to start driver for port "awc0"(error=0x00000000)

Hi there ,

wonder does anyone come across above error message recorded in your AP logs ( as below )

b)Warning Failed to Send Packet on port "awc0" (error=0xffffffff)

a) FATAL Failed to start driver for port "awc0" (errno=0x00000000)

Clients have to reassociate with these AP after deassociated.shall send these AP for RMA ? pls share ..thks

1 REPLY
New Member

Re: Failed to start driver for port "awc0"(error=0x00000000)

Check the config and make sure that your AP ports aren't configured with auxiliary vlans. Unless you plan on plugging in an IP phone to the same port as the AP you really only need to have the port configured for a single vlan. Hope that works for you.

Cheers!

Cisco_Kid

144
Views
0
Helpful
1
Replies
CreatePlease login to create content