Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Fast Ethernet and serial port

I have a Cisco 3620 router with 4 fast ethernet, 2 serial ports and 1 ISDN BRI S/T. To connect to my ISP, I'm using an Aironet 340 Wireless Bridge, tunneled through Fast Ethernet 0/0 on router. Is that configuration correct? Because I'm paying 128 Kbps to get 64 Kbps to my ISP. Do I have to connect the Aironet to the router via serial ports?

1 REPLY
Bronze

Re: Fast Ethernet and serial port

Your router should direct all LAN traffic to your ISP. This is independent of the Aironet. Just put your access point on your LAN and gateway everything at the router. Configure the router to gateway at the ISP.

354
Views
0
Helpful
1
Replies