Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FCC in Africa

Hi Team

We have a small problem with the AP's for a University in Africa. The 53 Cisco 1252 Access points that were designed are FCC.

That means on the WiSM I can't change the country code to ZA because the AP then doesn't report in. If I change it to US then the AP's say “RADIO LOW POWER”.

any way to get this right

Thanx in advance

1 REPLY
Hall of Fame Super Red

Re: FCC in Africa

Hi Tau,

This error "Radio Low Power" usually indicates a problem with PoE or power injector config. What are you using for the 1252's?? If you are using an "E" Series 3750 this is a very good thread;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Wireless%20-%20Mobility&topic=General&topicID=.ee6e8b8&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cc039db

Hope this helps!

Rob

130
Views
0
Helpful
1
Replies
CreatePlease login to create content