Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

FCS error rate, whas is normal?

Looking in the WCS reporting, Performance and selecting an AP gives some clues about the AP behavior. I have always increased "FCS error rate for a/n and b,g interfaces" on daytime, with high figures on the y-axis. I assume the figure is a summary (in spite of "error/s"), but what is normal or acceptable for the clients?

1 REPLY
Silver

Re: FCS error rate, whas is normal?

It depends on the usage of the network. Make sure the error rate is below 10 - 15% of the total transmitted packets.

178
Views
0
Helpful
1
Replies
CreatePlease to create content