Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Filter packets based on IP address at LWAPP access point.

Hello,

 

I was wondering if there was a way to filter packets based on IP address at a particular LWAPP access point.   The autonomous access points allow packet filtering, seems like there should be a method at the LWAPP controller level also to filter packets.

 

Regards,

 

Douglas Faron

 

1 REPLY
VIP Purple

In WLC based solution, you

In WLC based solution, you can apply an ACL  per interface or per WLAN. So there is no specific way of apply it to a single AP.

Here is some basics of ACL in WLC based on 7.0.116.0 code

http://mrncciew.com/2013/03/15/wlc-access-control-list-acl/

 

HTH

Rasika

 

29
Views
0
Helpful
1
Replies
CreatePlease login to create content