Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Filter to show APs with clients.

Hi,

How do I  create a filter by AP on my 4400 series WLC to show all the clients associated to those APs?  Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Filter to show APs with clients.

Samantha,

     This may be different depending on the version of code you are running, but this would be how you do it when running ver. 4.2.176.0

  1. Web into the Controller
  2. With the "Monitor" tab selected (home screen) click the "Clients" link on the left.
  3. Near the top click the "Change Filter" link
  4. Check the box next to "AP Name"
  5. Enter the name of the Access-Point you would like to filter by

That should be it.  Hope this helps.

3 REPLIES
New Member

Re: Filter to show APs with clients.

Samantha,

     This may be different depending on the version of code you are running, but this would be how you do it when running ver. 4.2.176.0

  1. Web into the Controller
  2. With the "Monitor" tab selected (home screen) click the "Clients" link on the left.
  3. Near the top click the "Change Filter" link
  4. Check the box next to "AP Name"
  5. Enter the name of the Access-Point you would like to filter by

That should be it.  Hope this helps.

New Member

Re: Filter to show APs with clients.

Thank you it worked.

Re: Filter to show APs with clients.

Great post Bragg 5+ !

If you have WCS you can pull this reporting as well!

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
243
Views
0
Helpful
3
Replies