Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

First Time RADIUS user

This is the first time I am attempting to use RADIUS and am possibly doing something wrong. I have a 1240 AG and am using the local RADIUS server on the AP. The encryption settings are WEP Mandatory and no key rotation. For the SSID in question I have authentication set to open with EAP and Network EAP. I have selected the local server as the EAP authentication server. I have created a local group and local user ID in the RADIUS server config and have associated it with the radios. When I attempt to connect (Dell 620 with Broadcom NIC) it associates with the access point and prompts me for a user ID and password. I have used the local ID created but it just fails the authentication at this point. Any clues as to what could be wrong. Using 12.4(3g)JA1. Thanks for your help and suggestions.

1 REPLY
Bronze

Re: First Time RADIUS user

All sounds ok but it could be that your Broadcom nic is not compatible: you should check what ccx version it supports because the access point performs LEAP, EAP-FAST

252
Views
0
Helpful
1
Replies
CreatePlease login to create content