Re: flapping log on switch (port connect to WirelessAP)
Others may disagree, but personally I don't think it is a problem. I used to see this occasionally with wireless devices that are roaming between autonoumous APs. Sometimes a wireless device will roam to an AP on another switch, and you will see the flap on a trunk. WPA2 devices are supposed to preauthenicate to the next AP before they roam I believe, so the hand off of the mac to the next AP may not be completely instant resulting in the mac-flap messages. If you only have this occassionally on wireless devices, I would not worry about it. If you see this on LAN attached devices you should investigate. You should not see this with controller based APs since the traffic is tunneled to the controller.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...