07-08-2014 01:41 AM - edited 07-05-2021 01:11 AM
Hi All.
I have 2 sites that are using Flexconnect AP's.
If I connect to the SSID, I am able to Ping & Telnet to my WLC & ISE Devices.
However. I'm unable to open a http or https connection to the devices.
I have no Access Lists blocking any traffic - I can open a https session up to the switch where the WLC & ISE device is connected to.
Any Ideas on this ?
07-10-2014 04:57 AM
You would have to enable Wireless connections to the web browser.
Use the following command.
config network mgmt-via-wireless enable
Hope that works.
07-10-2014 07:45 AM
it is enabled. that is how I access the WLC locally
07-10-2014 07:52 AM
you may also need to:
config network mgmt-via-dynamic-interface enable
for it to work
HTH,
Steve
07-10-2014 07:54 AM
Guys.
Please note I have this issue connecting to both my WLC & ISE Boxes
07-10-2014 07:56 AM
oh well then....Check L3 for an ACL that blocks mgmt of the devices from certain subnets.
HTH,
Steve
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: