07-08-2014 01:41 AM - edited 07-05-2021 01:11 AM
Hi All.
I have 2 sites that are using Flexconnect AP's.
If I connect to the SSID, I am able to Ping & Telnet to my WLC & ISE Devices.
However. I'm unable to open a http or https connection to the devices.
I have no Access Lists blocking any traffic - I can open a https session up to the switch where the WLC & ISE device is connected to.
Any Ideas on this ?
07-10-2014 04:57 AM
You would have to enable Wireless connections to the web browser.
Use the following command.
config network mgmt-via-wireless enable
Hope that works.
07-10-2014 07:45 AM
it is enabled. that is how I access the WLC locally
07-10-2014 07:52 AM
you may also need to:
config network mgmt-via-dynamic-interface enable
for it to work
HTH,
Steve
07-10-2014 07:54 AM
Guys.
Please note I have this issue connecting to both my WLC & ISE Boxes
07-10-2014 07:56 AM
oh well then....Check L3 for an ACL that blocks mgmt of the devices from certain subnets.
HTH,
Steve
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide