10-17-2005 06:38 AM - edited 07-04-2021 11:13 AM
Hello,
Hope this question is not too "newbie" but I was not sure...
I have an AP 1200, I wanted to know if the frequency had the same standard everywhere, meaning a AP under Swiss standard will work with a Wifi adaptor from, lets say, Israel? egal which freqency is used (EX 10 or 13).
Another point, when I configure the frequency 13, the PC can find the AP, is it normal?
Many thanks Gael
Solved! Go to Solution.
10-18-2005 04:42 AM
This document has the permitted band assignments:
http://www.cisco.com/en/US/products/ps6305/products_configuration_guide_chapter09186a00804ddd81.html
Here are the permitted channelsfor some countries:
http://www.cisco.com/en/US/products/ps5853/products_configuration_guide_chapter09186a008043ac4c.html
Good Luck
Scott
10-17-2005 11:24 AM
The channel assignments and their frequencies are international standards.
What may change is what channels a given country / region will support.
The client software should be able to recognize the channels in-use and adapt. The worst case, as best as I can figure it, would be that you may need to get client software specific to the country / region (i.e., MS Windows Zwro Wireless Config).
Good Luck
Scott
10-18-2005 12:20 AM
Hi Scott,
Many thanks for your answer,
Do you know if there is a dooument about which channel can be use in which country?
Gael
10-18-2005 04:42 AM
This document has the permitted band assignments:
http://www.cisco.com/en/US/products/ps6305/products_configuration_guide_chapter09186a00804ddd81.html
Here are the permitted channelsfor some countries:
http://www.cisco.com/en/US/products/ps5853/products_configuration_guide_chapter09186a008043ac4c.html
Good Luck
Scott
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: