Hope this question is not too "newbie" but I was not sure...
I have an AP 1200, I wanted to know if the frequency had the same standard everywhere, meaning a AP under Swiss standard will work with a Wifi adaptor from, lets say, Israel? egal which freqency is used (EX 10 or 13).
Another point, when I configure the frequency 13, the PC can find the AP, is it normal?
The channel assignments and their frequencies are international standards.
What may change is what channels a given country / region will support.
The client software should be able to recognize the channels in-use and adapt. The worst case, as best as I can figure it, would be that you may need to get client software specific to the country / region (i.e., MS Windows Zwro Wireless Config).
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...