Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Generate Report for Traffic Stream Metrics in WCS

Hi Cisco Support,

We tried to generate report for Traffic Stream Metric in WCS but got the error as follows:

Traffic Stream Metrics
Generated: Wed Nov 24 18:24:37 SGT 2010
Report By: AP By Controller
Protocol: 802.11a/n;802.11b/g/n
Reporting Period: Last 1 hour
The specified criteria did not match any data for the report.

Make sure that the following background tasks are running:

1.Traffic Stream Metrics
2.Radio Performance


How could we resolve this issue?

Please refer to attached and need your kind assistance.

Thanks.
Junhan

3 REPLIES

Re: Generate Report for Traffic Stream Metrics in WCS

Hi Junhan,

Can you make sure on the controller under Wireless > 802.1a/n and 802.1b/g/n > Voice that you have metrics 
collection checked because  Traffic Stream Metrics are for phones since it covers jitter, tx and rx amounts etc.  

This is the reason it has to be on voice enabled controllers.  You will not see it for clients. if you have

clients are desktop and laptop wireless devices then we will not get anything.

thanks,

Vinay

Thanks & Regards
New Member

Re: Generate Report for Traffic Stream Metrics in WCS

Hi Vinay,

I tried to enable Traffic Stream Metric under Wireless > 802.1a/n and 802.1b/g/n > Voice already in WLC but when i try to generate the report via WCS still shown as follows:

The specified criteria did not match any data for the report.

Make sure that the following background tasks are running:

1.Traffic Stream Metrics
2.Radio Performance

What would be the cause?

Thank You.
Junhan

New Member

Re: Generate Report for Traffic Stream Metrics in WCS

Hi Cisco Support,

When i try to enable Metrics Collection in WLC, i receive this error:

Unable to modify Media config while network is operational

Please refer to my attachment.

How can I resolve this issue?

Thanks.
Junhan

2006
Views
0
Helpful
3
Replies