We need to give an ip address to 1250 just for the managemnt purpose ( similar to VLAN1 ip address given in case of L2 switches ). And then Aironet1250's gigbit ethernet will be connected to our Core L3 4507 swicth which has DHCP running. And will distribute the IP address to wireless clients. In this case how to configure an ip address and also have DHCP running. Management IP adress is not in the range of the DHCP pool. so in case any configuration is required on Aironet device we will connect a notebook with a same subnet ip address as that of Aiornet device , and then telnet / ssh to management IP of aironet devive.
Any experience pls share.
Any configuration link on cisco.com is appreciated.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...