Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Guest Wireless Issues

Hi all. Hoping you can help me with 2 issues we have after setting up guest wireless using WLC rev

1. I set up the guest wlan with pass-through so we can have users accept terms of use. I created a custom page (login.html), created a tar file and downloaded onto the WLC. Applied the custom page but when I check preview it still shows the default page. The files are in the WLC but it seems like it is not being used. I've followed the directions I found but still would not use the custom page. Is there any special configuration for this?

2. When users connect to the guest wireless they see a security alert about the not trusting the certificate. I know this is because of https. If I disable https and just use http I don't get the alert. However we'd like to keep https not so much for the guest but for those managing the controllers. Is there a way to enable both http and https but force the login screen to use http?


Hall of Fame Super Silver

Re: Guest Wireless Issues

That is a bug on the 4.2 code... If the login page doesn't show after the certificate page then go back to the webauth page and change it back to internal and hit apply then change it back to custom webauth and hit apply.

As far as the certificate error, you have to install a 3rd party cert that is trusted. there is not a way to use http for the login.

hope this sort of answers your question.

*** Please rate helpful posts ***
Hall of Fame Super Silver

Re: Guest Wireless Issues

This link might help with the 3rd party cert:

*** Please rate helpful posts ***
CreatePlease login to create content