I've got this working without AP Groups. I've got a single WLAN so just the single SSID ( I actually don't broadcast the SSID, but that's beside the point)
You need to configure that WLAN to allow H-REAP Local switching, this setting is under the advanced tab. For the central site set access points to local AP Mode, for remote sites setup access point to H-REAP AP Mode. As long as you have your vlan and subnet information you should be oaky.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...