Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

H-REAP Question

I have a question about H-REAP. I'm using a 4402 with 10 1231 APs and two SSIDs (guest and staff). I'm expanding wireless to some of my other sites and want to use H-REAP with local switching. The APs going into the remote sites are 1241s so they do support H-REAP.

If I tell configure my staff SSID for H-REAP local switching, will the 10 older 1231 still central switch the SSID since they do not support H-REAP? Or will they just fail to work with that SSID?

Thanks,

Patrick

2 REPLIES
Hall of Fame Super Silver

Re: H-REAP Question

The 1240's support H-REAP with the 4.0 code on the WLC. Setting the WLAN to h-reap local switching allows you to use the ssid in either h-reap or local mode.

Hope this helps.

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a008081103d.shtml

-Scott
*** Please rate helpful posts ***
New Member

Re: H-REAP Question

Thanks for the information. I did a test last night and was able to have the same SSID work with H-REAP and central switching.

--Patrick

238
Views
0
Helpful
2
Replies