I need to do some HA setup between two Cisco 8510 controllers.
I only have the opportunity to connect the two redundant ports with 100 mbps switch link. Wil it work, or MUST it be gigabit connection?
The two 8510 will replace 2 x 5508, which today is used and is connected via 100Mb switch link.
By the way, what will happen to the HA WLC if its just the link between the 2 WLC that goes down. Will it start being active, although the primary actually still is active and it's just a redundant link that has gone down?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...