Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HELP WIRELESS MESH

Hi Guys

I need someone can help me please, my problem is this:

We have a wireless mesh network with 2 WLC and 24 LAP1510AG (4 RAPs), which are registered to the WLC 1 when tested HA, i turn off the WLC 1 to operate the WLC 2, there were only 12 of the 24 APs are registred with WLC 2, when we made the turn of the WLC 1 have been recorded the same 12.

the debug LWAPP events enable command only shows activity of registered APs.

We have set to factory defaults all APs register (12) but nothing.

Any help be welcome

Thank you very much

HG

4 REPLIES
New Member

Re: HELP WIRELESS MESH

Did you add the mesh mac addresses to the mac filtering database? That's usually the problem when mesh aps don't join our controllers.

New Member

Re: HELP WIRELESS MESH

if I added all the APs to the MAC-Filtering

New Member

Re: HELP WIRELESS MESH

The APs have been properly recorded with the WLC1, the problem arises when shut down WLC1 then the APs not registered with WLC2 only do 12.

New Member

Re: HELP WIRELESS MESH

Have you done

debug pm pki enable

on the controllers? You should see those messages even if you don't see the capwap messages.

150
Views
0
Helpful
4
Replies