All this has under cable is this USELESS information:
Cisco recommends a high-quality, low-loss cable for use with the antenna.
Note Coaxial cable loses efficiency as the frequency increases, resulting in signal loss. The cable should be kept as short as possible because cable length also determines the amount of signal loss (the longer the run, the greater the loss).
All I want to do is figure a way to use this at the back of my property. I have **no idea** how to connect this to my network. I currently use one of those "power ethernet adapter" style plugs which can extend the cable use for the yard and it works fine, but I need wireless. I was thinking that I can bring my newwork signal to the device using this method... so essentially I will have an ethernet port that is live that I can use.
HELP! I want to make this work if possible, don't mind spending a few dollars.
PLEASE DUMB DOWN YOUR ANSWER. I'M DUMMER THAN YOU THINK! (YES, DUMMER WAS ON PURPOSE!)
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...